Maycom MH-430 Manual do Utilizador

MINI HAND HELD TYPE UHF TRANSCEIVER USER'S OPERATION MANUAL MODEL : MH-430

In the above condition, press the " or " button to increase (decrease) Tone Frequency(Tone Channel No.). If you press and the hol

To deactivate : Press the "PTT" button. 3) BP(Beep) Button This feature gives the user an audible confirmation through a short be

5. MR, MW Button 1) MR(Memory Channel) Button A. TX/RX in the memory channel To access the stored channel No. in the memory, press the

Display of Memory channel Scan On/Off condition re-setting - Press the " or button, the memory channel scan skip On/Off will t

- During the Down(Up) scanning process, press the "()" button, then scanning direction will be changed to Down(Up) scanning pr

Display of Delete message NOTE : The deleted channel will be recovered when the radio will be On/Off. If only one channel will remai

To turn off the "Dual Watch" Channel, simply press the 'FUNC + SC/DW" button or press the "PTT" button. Note that

NOTE : - If you press "C" button in the Setting mode, current data will be stored and change to Call Mode. - If you pr

2) LOCK To Activate : Press the "FUNC + C(LOCK)" button. The " " will appear on the LCD to indicate that this feature i

1. TX Indicates that radio is in the "transmit" mode. 2. Function Mode Indicates the "FUNC" button has been selected. 3. DW

CONTENTS PAGE OPTION SETTING MODE...

6. Lock Indicates the "Key Lock" feature has been activated. 7. Beep Indicates that "Beep" tone confirmation is on. 8. Bell

16. CALL Indicates the CTCSS correct call.17. BUSY Indicates that RF signal received. 17

BATTERY PACK INSTRUCTION 1. Press down the battery lock button on the bottom side of the radio.( ) 2. Open the battery cover on the back side of the

TO TRANSMITPress and Hold the "PTT" button to transmit the signal. A. If Busy Channel Lock Out Option is on in the receiving mode, Busy

(at 4.5V) 3. TRANSMITTER SECTION POWER OUTPUT -------------------- 10mW OR

CTCSS TONE TABLE 20

maycom Co., Ltd Suite 463, APT Factory 201, Haan-dong, Kwangmyong-City, Kyong Ki-Do, Korea Kwangmyong P.O Box 77 OFFICE TEL : (02) 895-8091/3

OPTION SETTING MODEPress and hold "FUNC" button under the condition of Power off, andthen turn on the radio. To enter each option setting

NOTE : If you press "PTT" button on operating of Busy Channel Lock Out, error message will appear on the LCD and your ra

Display of Operating Power save On/Off setting Mode. If you press the " or " button in this setting mode, power save On/Off will tog

2. Squelch This control is to cut off or eliminate receiver background noise in the absence of an incoming signals. For maximum receiver sensi

1. Push-To-Talk(PTT) Button Press the "PTT" button and the transmitter is activated : you can now send a message. To receive, release

Display of RX Tone. Display of TX Tone. Display of SCAN Skip Condition. 2) Fr/Ch(Selection of Frequency or Channel) If you press the &

Display of Channel(RX/TX Channel) The last 2 small segments will show memoried channel number and balance 7 big segments will also show RX/